最近使用Visual Studio 2008時，發現相關數據庫選項下并沒有“發布到提供程序”，應該有的呀！

隨vs2008自帶的是1.2版本，vs2008 sp1將升級為1.3版本，可能是vs2008sp1安裝出錯了吧:

下面的參考很有價值：

Microsoft SQL Server Database Publish Wizard 1.3 is not fully repaired from Add or Remove Programs

If you try to repair 'Microsoft Sql Server Database Publishing Wizard 1.3' (the version that gets installed with Visual Studio 2008 Service Pack 1 or Visual Web Developer 2008 with SP1) by using Add or Remove Programs, you might encounter one of the following problems:

a. Repair button is not available under 'Microsoft Sql Server Database Publishing Wizard 1.3' component.

b. Repair button is available, but performing a repair causes an older version of the wizard 'Microsoft Sql Server Database Publishing Wizard 1.2' to be installed.

c. Repair button is available, but performing a repair causes a prompt for the source of SqlPubWiz.msi.

To resolve this issue (Windows XP / Vista):

1. Open Control Panel and go to Add or Remove Programs.

2. Right-click the component 'Microsoft Sql Server Database Publishing Wizard 1.3' (or 'Microsoft Sql Server Database Publishing Wizard 1.2' if this older version was installed due to (b) above), and then click Uninstall. Wait for uninstallation to finish.

3. Run SqlPubWizInstaller.exe from http://go.microsoft.com/fwlink/?LinkId=119368  to re-install 'Microsoft Sql Server Database Publishing Wizard 1.3'. You can verify that it was installed by looking in Add or Remove Programs.

Note, on my PC the installer runs and then just disapears without any success/failure message, but it did the trick all the same.

（來源：ASP.NET Forums）

按他的要求重裝了Database Publish Wizard 1.3，果然解決！

……小料：如果單獨安裝sql server的話，也可以直接訪問數據庫發布向?qū)У模?/p>

• sql